WD-40 Specialist Fast Drying Contact Cleaner Spray 360ml
- Stock: In Stock
- Model: CC-360ml
- Weight: 0.39kg
- Dimensions: 7.50cm x 7.50cm x 21.00cm
190 samples sold
Product Views: 6746
RM33.60
Ex Tax: RM33.60
NOTE
DELIVERY TO WEST MALAYSIA ONLY.
- CAN NOT DELIVER TO EAST MALAYSIA (SABAH & SARAWAK), BECAUSE IT IS FLAMMABLE AND LIQUID PRODUCT
IT IS A DANGEROUS GOODS FOR AIR DELIVERY.
PERFECT FOR CLEANING ELECTRICAL EQUIPMENT, CONTACTS AND PLASTICS
Cleans away oil, dirt, flux residue and condensation from sensitive electronics and electrical equipment, by rapidly penetrating hard-to-reach areas and dries quickly without leaving any residue
✔ Dielectric strength up to 35,000 Volts per 0.1 inch
✔ Fast-acting, non-conductive cleaner
✔ Penetrates quickly, fast drying and leaves no residue
✔ ROHS Compliance
✔ Perfect for cleaning electrical equipment, contacts and plastics
RECOMMENDED USES
▪ Printers & Copiers
▪ Precision Instruments
▪ Controls
▪ Circuit Boards
▪ Switches
▪ Tape Heads
▪ Electrical Assemblies
APPLICATIONS
▪ Circuit Boards
▪ Switches
▪ Printers
▪ Controls
DIRECTIONS
Isolate all electricity and allow hot surfaces to cool. Make sure all stored power is drained from the system. Shake can well before use. Hold can 15cm to 20cm away from the surface and spray directly on to the electronic device or circuit board to eliminate and remove contaminants that may cause loss of electrical contact. Tilt surface while cleaning and allow any excess cleaner to run off. Allow product to dry completely and thoroughly vent the system before restoring power.
